FMI Outland Living 420 Series Owner's Manual
  1. Manuals
  2. Brands
  3. FMI Manuals
  4. Outdoor Fireplace
  5. Outland Living 420 Series
  6. Owner's manual

FMI Outland Living 420 Series Owner's Manual

Fire table
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Model number FMPPC2E-420
FMI BRANDS INC.
107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7 | Toll Free 1-888-514-1663 | Fax 1-888-797-9931
Outland Living is a registered trademark of FMI Brands Inc. The OUTLAND Flame mark is a registered trademark of FMI Brands Inc.
FIRE TABLE
Owner's Manual
NOTICE : THIS
PRODUCT CONTAINS A
THERMOCOUPLE SAFETY
DEVICE WHICH SHUTS
OFF THE GAS. PLEASE
READ THE INSTRUCTIONS
CAREFULLY TO
UNDERSTAND HOW IT
WORKS.
D.420.000.V0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Outland Living 420 Series and is the answer not in the manual?

Questions and answers

Related Manuals for FMI Outland Living 420 Series

Summary of Contents for FMI Outland Living 420 Series

  • Page 1 107 – 19052 26 Avenue | Surrey, B.C. Canada V3Z 3V7 | Toll Free 1-888-514-1663 | Fax 1-888-797-9931 Outland Living is a registered trademark of FMI Brands Inc. The OUTLAND Flame mark is a registered trademark of FMI Brands Inc.

  • Page 2: Carbon Monoxide Hazard

    Owner & Safety Manual Model number FMPPC2E-420 - Tested by CSA International ANS Z21.97-2017/CSA 2.41-2017 Outdoor Decorative Gas Appliances DANGER: FIRE OR EXPLOSION HAZARD If you smell gas: 1 Shut off gas to the appliance. WARNING! HOT SURFACE! 2 Extinguish any open flame. 3 If odour continues, leave the area immediately.

  • Page 3: Minimum Clearances

    Never fill the cylinder beyond 80 percent full. Replacement parts and a list of such parts are available from FMI Brands Inc. through the contact information provided on the last c.

  • Page 4: Gas Cylinder

    Owner & Safety Manual GAS CYLINDER: All LP cylinders to be used with this appliance must be: a. Constructed and marked in accordance with the U.S. Department of Transportation (DOT) Specifications for LP-Gas Cylinders, or the Standard for Cylinders, Spheres and Tubes for Transportation of Dangerous Goods, CAN/CSA B339, as applicable.
  • Page 5 PRE-IGNITION INSPECTIONS Should you have any questions or comments regarding this appliance, please do not hesitate to contact FMI Brands Inc. at GAS HOSE INSPECTION (888) 514-1663 or E-Mail to info@outlandliving.com Clean and inspect the hose before each use of the appliance.
  • Page 6 Owner & Safety Manual Supplied parts & hardware list: PART # DESCRIPTION QUANTITY PICTURE PART # DESCRIPTION QUANTITY PICTURE Assembly Work Surface (Top Foam Packing Insert) Side Panel Table Top Frame with Tempered Glass M6 screw (+ 1 extra) End Panel with Gas Glass Fire Rocks 1 Bag Valve, Gas Hose...
  • Page 7 SECTION 1: ASSEMBLY STEP 1 WARNING: Resist the urge to cut straps until STEP 5B. Lay the table top frame with tempered glass on a flat non-marking DO NOT CUT STRAPS WITH TABLE TOP STANDING UP. surface. Use cardboard or foam provided in packing box as a work surface.
  • Page 8 Owner & Safety Manual SECTION 1: ASSEMBLY (continued) STEP 2A ***Loosely install*** the End panel with gas valve, gas (4x) M6 SCREWS hose and regulator mounting bracket assembly to the table END PANEL WITH GAS VALVE, GAS HOSE AND top with 4 screws, but do not tighten. REGULATOR MOUNTING BRACKET ASSEMBLY IMPORTANT: Align gas valve orifice inside burner tube.
  • Page 9 SECTION 1: ASSEMBLY (continued) STEP 2B STEP 2C Connect the igniter cable to the gas valve igniter. Connect the round thermocouple cable to the thermocouple socket. Push Hard! IGNITER CABLE ROUND THERMOCOUPLE CABLE GAS VALVE IGNITER THERMOCOUPLE SOCKET NOTE THE SMALL RECTANGULAR CONNECTION MAKE SURE THE SILICONE COVER ON THE IGNITER CABLE WIRE IS PRESSED UP AGAINST THE GAS VALVE CONNECTION.
  • Page 10 Owner & Safety Manual SECTION 1: ASSEMBLY (continued) STEP 3 (4x) M6 Mount End Panel ***loosely***, but do not tighten. SCREWS END PANEL En-9 OUTLAND LIVING FIRE TABLE OWNER & SAFETY MANUAL ® D.420.000.V0...
  • Page 11 SECTION 1: ASSEMBLY (continued) PROPANE CYLINDER STEP 4A H-FRAME SUPPORT (2X) THIS WAY UP Locate the (4x) press-fit studs on the End ARROWS Panels. Mount the Propane Cylinder H-Frame Support onto the press fit studs of the End Panels. Fit the holes in the ends of the H-Frame Support over the studs of one End Panel.
  • Page 12 Owner & Safety Manual SECTION 1: ASSEMBLY (continued) STEP 5A Turn fire table upright. Carefully remove the (2x) This Way Up Arrow stickers from the Propane Cylinder H-Frame Support. HEAVY OBJECT. TWO PERSON LIFT REQUIRED. STEP 5B Cut and remove straps. SCISSORS KNIFE METAL...
  • Page 13 SECTION 1: ASSEMBLY (continued) STEP 6: PROPANE CYLINDER ASSEMBLY Place an approved 20lb propane cylinder into the cylinder ring (Part 6). Couple the supplied gas regulator to the propane cylinder (see section labeled “Connection”). Perform LEAK TEST on all gas couplings (see section labeled “Leak Test”).

  • Page 14: Step 7: Side Panel Assembly

    Owner & Safety Manual SECTION 1: ASSEMBLY (continued) FINGER LIFTS STEP 7: SIDE PANEL ASSEMBLY Assemble (2x) Side Panels by fitting side panel tabs (2x) SIDE PANELS on cross bars and pushing closed. To remove, simply use the finger-lifts and lift panel away. FINGER LIFTS STEP 8: GLASS ROCKS ASSEMBLY...

  • Page 15: Note To User

    SECTION 1: ASSEMBLY (continued) STEP 9 WARNING: Your OUTLAND Fire Table is assembled and ready for use. Never handle glass rocks which have not been allowed to cool from exposure to flame. Never attempt to rearrange glass rocks while unit is ignited. WARNING: Avoid glass dust.
  • Page 16 Owner & Safety Manual SECTION 2: IGNITION STEP 1 Remove any cover, or lid, from the fire table. Make sure no debris or flammable material is in or near the burner tray area. STEP 2 Ensure that the gas valve knob is in the “OFF” position by pushing and turning clockwise until the dial stops. STEP 3 Connect the LP gas cylinder.
  • Page 17 SECTION 2: IGNITION (continued) STEP 7 IGNITION WITH THERMOCOUPLE PUSH THE KNOB IN AND QUICKLY TURN TO THE Your Fire Table is equipped with an auto spark ignition (piezo ignition) and HIGH FLAME MARK thermocouple. IMPORTANT: • Confirm the igniter cable is connected. •...

  • Page 18: Troubleshooting

    Owner & Safety Manual SECTION 3: TROUBLESHOOTING FIRE TABLE WON’T LIGHT? IGNITION PROBLEM? IGNITION TROUBLESHOOTING STEP 1 Wait 5 minutes for any gas to dissipate. IF YOU CANNOT GET SPARK: IF YOU GET SPARK, BUT THERE IS NO GAS, OR THE GAS KEEPS SHUTTING OFF: 1.
  • Page 19 SECTION 3: TROUBLESHOOTING (continued) STEP 2 1. Wait until the glass rocks are cool, or wait 5 minutes for any gas to dissipate, whichever is longer. 2. Turn the gas cylinder valve to the ‘Closed’ position. 3. Open the fire table gas knob control for 3 seconds to release gas pressure. 4.
  • Page 20 Owner & Safety Manual SECTION 3: TROUBLESHOOTING (continued) GOT A LOW FLAME? NOTE: Elevation and temperature affect the cylinder gas pressure and performance (flame height) of gas appliances. Your geographic location or local weather may be at fault. STEP 1 Check propane level.
  • Page 21 SECTION 5: FIRE TABLE MAINTENANCE Your Outland Fire Table requires periodic maintenance to keep it in good running order. Follow the steps below to ensure your appliance will provide you with the best possible performance: Keep your Fire Table out of the rain and store it in a dry place. Fire Table accessories such as covers can be purchased at www.outlandliving.com or by calling 888-514-1663.

  • Page 22: Warning Notes

    Owner & Safety Manual WARNING NOTES: • Expected burn time; the anticipated burn time for your Outland • Do not place any objects other than supplied rocks inside the Fire Table using a full 20 lb (9kg) propane cylinder is between 8 burner component of the Fire Table.
  • Page 23 REMOVING INSECT NESTS STEP 4 Remove the gas valve body assembly. WARNING: STEP 5 Small critters like Use a flashlight to look inside the burner tube. Use a long flexible spiders and earwigs pipe cleaner, or long small utensil to clean out any debris or nest can quickly build nests material.

  • Page 24: Year Limited Warranty

    Replacement part orders can be sent by mail to the address on the cover of this booklet, or faxed to (888) 797-9931. Should you have any questions or comments regarding this appliance, please do not hesitate to contact FMI Brands Inc. at (888) 514-1663 or E-Mail to info@outlandliving.com.

This manual is also suitable for:

Outland living fmppc2e-420

Table of Contents