Audiovox Prestige Platinum APS-997C Owner's Manual page 17

ADDITIONAL ICONS THAT MAY BE DISPLAYED ARE
If the arm/disarm chirp tones have been turned off at the
vehicle, when you arm, or disarm, the display will indicate
this as shown and there will be no arm/disarm chirps at the
transmitter. This is true if the transmitter is set for vibrate mode.
When the vehicle is armed, and a door is opened, or ajar, the transmitter will
chirp 3 times, the lights will flash, and the display will indicate a door trigger as
shown on the previous page. When the door is closed or the zone clears, the
transmitter will chirp 1 time, and the display will clear.
When the vehicle is armed, and the hood or trunk, is opened or ajar, the
transmitter will chirp 3 times, the lights will flash, and the display will indicate a
hood or trunk trigger as shown on the previous page. When the hood or trunk
is closed, or the zone clears, the transmitter will chirp 1 time, and the display
will clear.
PROGRAMMED TRANSMITTER NOTIFICATION (PTN)
Every time after Disarm when the ignition key is turned on, the unit's LED will
report the number of transmitters programmed into the system. This safety
feature will alert you if an unauthorized transmitter has been programmed
into your vehicle's security system without your knowledge. Typical from the
factory, there will be a 2 flash, pause, repeated 3 times indicating that two
transmitters are programmed into the system. If you note additional flashes,
there may heve been an additional transmitter added without your knowledge
or authorization. If you notice a change in the transmitter LED report pattern,
you can correct this by looking up how to erase and reprogram your transmit-
ters found in the transmitter programming guide. This reprogram operation will
erase all unauthorized or unwanted transmitters.
ADDITIONAL REMOTE FEATURES:
The two way remote control unit allows you to access status
information from the vehicle, check temperature, light the
display, toggle the transmitter from beep tones to vibrate
mode, initiate daily start timer, and temperature start. Selec-
tion of these and other features are shown below:
NOTE: Transmitter must be within operating range of the
vehicle, approximately 1000 ft.
Check Vehicle Status
Press the lock+key+option buttons simultaneously for 1
second. The vehicle's alarm will display the systems current
status.
Check Temperature (Only available on certain remote
start units)
Press the option+key buttons simultaneously for 1 second.
The vehicle's alarm will display the temperature. Tempera-
ture is read from the alarm's module located below the dashboard.
Page 17
128-8774c
17 of 24