Download Print this page

Playcore Colorado Time Systems F1057 Instructions

Start system flagpole mount

Start System Flagpole Mount Instructions

Tool Required: Phillips screwdriver

1. Separating the mounting plate and the mounting bracket: The mounting

bracket and the mounting plate are attached to each other to prevent damage in

shipping. Loosen the thumbscrew that holds them together and take them apart.

2. Fastening the mounting plate: Attach the mounting plate (the flatter piece) to

the bottom of your start system with the screws provided (you'll need 3 or 4,

depending on your start system).

3. Attaching the bracket assembly to your flagpole: Open the clamp. Position

on your flagpole. Close clamp and tighten with thumbscrew.

1551 E. 11

Street, Loveland, CO 80537| +1 970-667-1000 | +1 970-667-1032 (fax) | 800-287-0653 | www.coloradotime.com | support@coloradotime.com

Tripod

Bracket

F1057 Rev. 202009

Mounting

Bracket

Table of Contents

Do you have a question about the Colorado Time Systems F1057 and is the answer not in the manual?

Page 1 Start System Flagpole Mount Instructions Tool Required: Phillips screwdriver 1. Separating the mounting plate and the mounting bracket: The mounting bracket and the mounting plate are attached to each other to prevent damage in shipping. Loosen the thumbscrew that holds them together and take them apart. Mounting Tripod Bracket...
Page 2 4. Check mounting bracket: Align the mounting bracket on the top of the bracket assembly so that the narrow end is facing away from the pole. Loosen the thumbscrew on the side if needed. When aligned, tighten the thumbscrew on the side until just snug.