Memory Upgrade Module; Installing Memory Upgrade Modules; To Remove A Memory Upgrade Module - Fujitsu Lifebook S6110 User Manual

Memory Upgrade
Module
Your Fujitsu LifeBook notebook comes with a minimum
of 256MB of high speed Synchronous Dynamic RAM
(SDRAM), 133MHz factory installed. To increase your
LifeBook notebook's memory capacity, you may install an
additional memory upgrade module. The memory
upgrade must be a dual-in-line (DIMM) SDRAM
module. To ensure 100% compatibility, purchase the
SDRAM module only from the Fujitsu web store at
www.fujitsupc.com.
C A U T I O N S
Do not remove any screws from the memory upgrade
■
module compartment except the ones specifically
shown in the directions for installing and removing
the memory upgrade module.
The memory upgrade module can be severely dam-
■
aged by electro-static discharge (ESD). Be sure you
are properly grounded when handling and installing
the module.

INSTALLING MEMORY UPGRADE MODULES

1. Turn off power to your LifeBook notebook and
remove any power adapter (AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the notebook bottom side up, and remove the
screws of the memory upgrade module compart-
ment. (Figure 4-8)
4. Remove the cover.
Figure 4-8. Opening the Memory Upgrade Compartment
5. Remove the memory upgrade module from the
static guarded sleeve.
6. Align the memory upgrade module with the part
side up. Align the connector edge of the memory
upgrade module with the connector slot in the
compartment.
7. Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
U s e r I n s t a l l a b l e F e a t u r e s
retaining clip. You will hear a click when it is prop-
erly in place. (Figure 4-9)
Figure 4-9. Installing a Second Memory Module
8. Replace the cover.(Figure 4-10)
9. Replace the screws.
Figure 4-10. Replacing the Memory Compartment Cover
P O I N T
The memory upgrade module is not something you
routinely remove from your notebook. Once it is
installed, you can leave it in place unless you want to
change system memory capacity.

TO REMOVE A MEMORY UPGRADE MODULE

1. Perform steps 1 through 4 of Installing a Memory
Upgrade Module.
2. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook. (Figure 4-11)
Figure 4-11. Removing a Memory Upgrade Module
45