Panasonic KX-FL323HK Operating Instructions Manual page 5

Installation and relocation
After moving the unit from cold areas to
warmer areas, wait approximately 30
minutes before connecting the unit to allow
the unit to adjust to the ambient
temperature. If the unit is connected too
soon after a sudden climate change,
condensation may form inside the unit,
causing malfunction.
Never install telephone wiring during a
lightning storm.
Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone wires or
terminals unless the telephone line has
been disconnected at the network interface.
Use caution when installing or modifying
telephone lines.
Laser radiation
CLASS 1 LASER PRODUCT
The printer of this unit utilises a laser. Use of
controls or adjustments or performance of
procedures other than those specified
herein may result in hazardous radiation
exposure.
Laser diode properties
Laser output : Max. 5 mW
Wavelength : 760 nm – 810 nm
Emission duration : Continuous
LED light
CLASS 1M LED PRODUCT
Do not view directly with optical instruments.
LED light of CIS properties
LED radiation output : Max. 1 mW
Wavelength : Green 520 nm typ.
Emission duration : Continuous
Fuser unit
During or immediately after printing, the
fuser unit gets hot. This is normal. Do not
touch the fuser unit.
1
Fuser unit
Note:
L The area near the recording paper exit (1) also gets
warm. This is normal.
Toner cartridge
Be careful of the following when you handle the toner
cartridge:
If you ingest any toner, drink several glasses
of water to dilute your stomach contents,
and seek immediate medical treatment.
If any toner comes into contact with your
eyes, flush them thoroughly with water, and
seek medical treatment.
Important Information
5