Before Using The Wireless Lan; Wireless Lan Modes Using This Device; Activating The Wlan Device - Fujitsu Lifebook N3410 User Manual

Fujitsu lifebook n3410: user guide
Hide thumbs Also See for Lifebook N3410:
Table of Contents

Advertisement

L i f e B o o k N S e r i e s N o t e b o o k - S e c t i o n F i v e

Before Using the Wireless LAN

This manual describes the procedures required to prop-
erly setup and configure the integrated Wireless LAN
Mini-PCI device (referred to as "WLAN device" in the
rest of the manual). Before using the WLAN device, read
this manual carefully to ensure it's correct operation.
Keep this manual in a safe place for future reference.
Wireless LAN Device Covered by this Document
This document is applicable to systems containing an
Intel PRO/Wireless 2200BG Mini-PCI wireless network
card.
Characteristics of the WLAN Device
The WLAN device is a Mini-PCI card attached to the
main board of the mobile computer.
It operates in the license-free 2.4GHz Industrial, Sci-
entific, and Medical (ISM) RF band, therefore elimi-
nating the need to procure an FCC license to operate.
It is capable of two operating modes, IEEE802.11b and
IEEE802.11g, wireless LAN standards governed by the
IEEE (Institute of Electronics and Electrical Engi-
neers).
Encoding of data is modulated using Direct Sequence
Spread Spectrum (DSSS) and Complementary Code
Keying (CCK) when the WLAN device is operating in
IEEE 802.11b mode and Orthogonal Frequency Divi-
sion Multiplexing (OFDM) when operating in IEEE
802.11g mode.
Figure 5-1. Ad Hoc Mode Network
50
The WLAN device is Wi-Fi certified and operates at
the maximum data transfer rate of 54 Mbps in
IEEE802.11g mode and 11 Mbps in IEEE802.11b
mode.
The maximum communication range indoors is
approximately 80 feet (25 meters). However, that
range will increase or decrease depending on factors
such as number of walls, reflective material, or inter-
ference from external RF sources.
The WLAN device supports the following encryption
methods - WEP, TKIP, and AES encryption.

WIRELESS LAN MODES USING THIS DEVICE

Ad Hoc Mode
(See Figure 5-1)
"Ad Hoc Mode" refers to a wireless network architecture
where wireless network connectivity between multiple
computers is established without a central wireless
network device, typically known as Access Point(s).
Connectivity is accomplished using only client devices in
a peer-to-peer fashion. That is why Ad Hoc networks are
also known as peer-to-peer networks. Ad Hoc networks
are an easy and inexpensive method for establishing
network connectivity between multiple computers.
Ad Hoc mode requires that the SSID, network authenti-
cation, and encryption key settings are identically
configured on all computers in the Ad Hoc network.

Advertisement

Table of Contents
loading

Table of Contents