Internal Floppy Disk Drive; Loading A Disk; Ejecting A Disk; Preparing A Disk For Use - Fujitsu Lifebook N3010 User Manual

Internal Floppy Disk Drive

An internal floppy disk drive is installed in the left side
of your LifeBook notebook. The floppy disk drive can
read and write information on removable 1.44MB and
720KB floppy disks.
P O I N T
Your LifeBook notebook is preconfigured to boot from a
floppy drive. Reference the BIOS manual for further
information on changing the default boot drive. The
BIOS manual can be found on the Fujitsu PC web site:
www.FujitsuPC.com, under Support.

LOADING A DISK

To load a disk into your disk drive, follow these steps:
1. Orient the disk so that its label is facing upwards
and the shutter side is pointing towards the drive.
(Figure 4-2)
2. Push the disk into the drive until the Eject button
pops out and you hear a click.
P O I N T
When there is no disk in the drive, the Eject button is
flush with your notebook.

EJECTING A DISK

To eject a disk from the disk drive, follow these easy
steps:
1. Check that the Floppy Disk Drive Access indicator
is inactive.
2. Press the Eject button. This will push your disk
partially out of the drive.
3. Remove the disk.
Figure 4-2 Loading/Ejecting a 3.5" Floppy Disk
If you eject the disk while the Floppy Disk Drive Access
indicator is active, there is a risk of damaging the data
on the disk, the disk itself or even the disk drive.

PREPARING A DISK FOR USE

Before you can use a new disk, it needs to be prepared
so your LifeBook notebook knows where to store infor-
mation. This preparation is called formatting or initial-
izing a disk. You will need to format new disks, unless
they are preformatted. (Please refer to your operating
system manual for step-by-step instructions on formatting a
disk)
To prevent accidental erasure of the data stored on a
disk, slide the "write protect" tab until a small hole is
exposed. This sets the disk into a protected state where
nothing can be added or removed. If you want to add or
remove data on a protected disk, slide the "write
protect" tab to close the small hole. (Figure 4-3)
Formatting a floppy disk that already contains data will
erase all of the information on the disk.
U s e r - I n s t a l l a b l e F e a t u r e s
1
1 Floppy Disk Drive
Eject Button
C A U T I O N
1
1 Write Enabled
2 Write Protected
Figure 4-3 Floppy Disk Write Protect
C A U T I O N
2
39