Table of Contents
Advertisement
L 6HULHV$ERRN 3DJH 7KXUVGD\ -XQH 30
Problem
USB Device Problems
You have installed a USB
device. Your LifeBook does
not recognize the device, or
the device does not seem to
work properly.
PC Card Problems
A card inserted in the PC
Card slot does not work or
is locking up the system.
Power Failures
You turn on your
LifeBook and nothing
seems to happen.
Possible Cause
The device is not
properly installed.
The device may have been
installed while an application
was running, so your LifeBook
is not aware of its installation.
Your software may not have
the correct software driver
active.
The card is not
properly installed.
The card may have been
installed while an application
was running, so your LifeBook
is not aware of its installation.
Your software may not
have the correct software
driver active.
You may have the wrong
I/O address selected for your
PC Card device.
Your PC Card device and
another device are assigned the
same I/O address.
The installed primary
battery is completely
discharged, there is no
optional second battery
installed or there is no
Power adapter (AC or Auto/
Airline) installed.
The primary battery is
installed but is faulty.
The battery or batteries are low. Check the Status Indicator Panel to determine the
T r o u b l e s h o o t i n g
Possible Solutions
Remove and re-install the device. (See Device Ports
on page 50 for more information)
Close the application and restart your LifeBook.
See your software documentation and activate the
correct driver.
Remove and re-install the card. (See PC Cards on
page 46 for more information)
Close the application and restart your LifeBook.
See your software documentation and activate the
correct driver.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the BIOS. (See BIOS Setup Utility on page 31 for
more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check the Status Indicator Panel to determine the
presence and condition of the batteries. (See Status
Indicator Panel on page 15 for more information)
Install a charged battery or a Power adapter.
Use the Status Indicator panel to verify the presence
and condition of the batteries. (See Status Indicator
Panel on page 15 for more information) If a battery is
indicating a short, remove that battery and operate
from another power source or replace that battery.
presence and condition of the batteries. (See Status
Indicator Panel on page 15 for more information) Use
a Power adapter to operate until a battery is charged
or install a charged battery.
59
Advertisement
Chapters
Table of Contents
Troubleshooting
