Advertisement
o Use 8mm socket wrench (not provided) on either of the hex shaft ends in side wall 1
and turn them in their designated direction (bevel hex in counter clockwise direction
and hub gear in clockwise direction- see Figure 9). IMPORTANT: Use wrench to
open gripper only as far as is necessary to install security set screws. Opening
gripper further with socket wrench will damage gripper.
Once in the open position, insert the security set screws so they touch the rotating
o
shaft.
Note: Before changing shoes or spacers, install security set screws to prevent unintended
"ROPE GRIPPER™" activation, leading to severe personal injury and/or damage to the
unit.
Figure 9 - Gearbox (Side Wall 1) of 622G Rope Gripper
9/4/2015
TM
BULLETIN 1166
Page 8 of 20
Advertisement
