Fujitsu Lifebook E7010 User Manual page 118

B5FH-4491-01EN-00.book Page 112 Friday, April 19, 2002 11:24 AM
L i f e B o o k E S e r i e s – A p p e n d i x
the encryption keys set for the access point, refer to
the manual supplied with the access point.
P O I N T
Be sure to specify the encryption keys. If you do not
specify the keys, any computer with a wireless LAN card
can be connected. This presents a risk that other users
may steal or destroy your data.
Item
Network Enter the network name to which you
Name want to connect. This is a required item.
SSID For the network name, ask your LAN
administrator.
AdHoc network: Set the same name for all
of the computers that are to be connected.
Infrastructure network: Specify the same
name as that specified on the access point
that is to be connected. For access point
instructions, refer to the manual that
comes with the access point.
Key Click the down arrow and select the input
Format for the Network key.
ASCII Select this when using
characters ASCII characters for the
Network Key. Characters
that can be used follow:
0-9, A-Z, a-z, and
_ (underscore)
Example: To set the key to
"ABC12", input "ABC12".
Hexa- Select this when using
decimal hexadecimal characters for
characters the Network Key.
Use this if there is a wireless
LAN card in the network
that has the Network Key
set to a character code. In
'Network Key', input the
same value as the other
wireless LAN card.
Table 12: Setting parameters
8. When you finish your entry, click [OK]. [Wireless
Network Connection 2 Properties] appears again.
9. Make sure the network name you specified for the
SSID in Step 7 is added under [Preferred networks].
112
Description
Network Connection
The section describes how to set the network connection
for a computer running Windows XP.
Network Settings
In this section, you set "TCP/IP Settings," and complete
"Checking Computer Name and Workgroup" required
for the network connection.
TCP/IP Settings
1. On [Wireless Network Connection Properties], click
[General].
P O I N T
If [Wireless Network Connection 2 Properties] is not
displayed, click [Start] -> [Settings] -> [Control Panel],
and double-click the [Network Connection] icon.
Right click the [Wireless Network Connection], and
then click [Properties] from the menu that appears.
2. Perform the following steps.
Click [Internet Protocol (TCP/IP)].
I
Click [Properties]. [Internet Protocol (TCP/IP)
I
Properties] appears.
3. Set an IP address. Ask your network administrator
and check the setting.
Item Description
AdHoc Set the IP address and subnet mask.
Network Click [Use the following IP address].
Enter a value for [IP address] and
[Subnet mask]. See "Setting IP
Addresses" on page 120 to set IP
address and subnet mask.
For Select [Obtain an IP address
Infrastructure automatically]. For the DNS server,
Network select [Obtain DNS server address
automatically]. For the IP address,
DNS server, and default gateway,
follow the network administrator's
instructions, if any.
Table 13: Setting an IP address
5. Click [OK].
P O I N T
If you have changed the setting, [Close] is shown
instead. Click [Close].
6. Close [Network Connection].