Table of Contents
Advertisement
en Installation and connection
WARNING
Risk of electric shock!
The appliance contains live parts.
Touching live parts is dangerous.
Do not operate the appliance
▶
without a cover cap.
WARNING
Risk of injury!
When using the appliance on a base,
the appliance may tip over.
Always secure the feet of the appli-
▶
ance to a base using the manufac-
turer's fixing brackets → Page 33
before using the appliance for the
first time.
ATTENTION!
The appliance may contain residual
water. If you tilt the appliance beyond
40°, this residual water may leak out.
Tilt the appliance carefully.
▶
Installation loca-
tion
Base
Wooden joist
floor
Kitchen unit
14
Requirements
Secure the appli-
ance with fixing
brackets
→ Page 33.
Place the appli-
ance on a water-
resistant wooden
board (minimum
thickness of
30 mm) which is
screwed tightly to
the floor.
Only install the
appliance under-
neath a continu-
ous worktop that
is securely con-
nected to adja-
Installation loca-
tion
ATTENTION!
Freezing residual water Freezing re-
sidual water may damage the appli-
ance and frozen hoses may burst.
Do not install the appliance out-
▶
doors or in areas where there is a
risk of frost.
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡ Observe the information on safety
→ Page 4 and preventing material
damage → Page 11.
¡ Keep the transit bolt screws and
the sleeves in a safe place for fu-
ture transport → Page 58.
Pull the hoses out of the holders.
1.
Requirements
cent cabinets.
Required niche
width: 60 cm.
Advertisement
Table of Contents
