Product Specifications - Homewerks Worldwide H13L-421-CH Quick Start Manual

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 1.8 GPM (6.8 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Polished chrome, brushed nickel or oil rubbed bronze
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Place the gasket (1) onto the bottom
of the new faucet assembly (2). Place
the faucet assembly (2) through the
mounting holes in the sink. Secure the
faucet assembly (2) to the sink using
the mounting nuts (3) provided.
NOTE: If the sink is uneven, use
silicone under the gasket (1).
3. Push the quick connector (1) firmly
upward and attach it to the
receiving block (2). Pull down
moderately to ensure the connec-
tion has been made. If it is necessary
to remove the quick connector (1),
squeeze the tabs on the quick
connector and then pull down to
disconnect.
4. Install the weight clip (1) at the point
of the hose marking "weight here".
Insert the weight (2) onto the clip
(1) by sliding it down onto the clip
(1).
1
2
2
1
3
3
2
1
4
2
2
1
1
Ceramic cartridge
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
Make Connections to
5.
Water Lines:
Use 1/2 in. I.P.S. faucet connections
(2), or use supply line coupling nuts
(3) (not included) with a 3/8 in. O.D.
ball-nose riser (1). Use wrenches
(not included) to tighten the
connections. Do not overtighten.
Preparing for Installing
6.
Pop-up Assembly:
Remove the bottom gasket (1) and
nut (2) from the top gasket (3) and
pop-up body (4). Attach these pieces
together by pushing the bottom
gasket (1) down into the top of the
nut (2) and twisting together.
Installing the Pop-up Body:
7.
Insert the pop-up body (1) into the
sink. Ensure that the top gasket (2)
rests securely between the top of
the sink and the top of the pop-up
body (1).
Securing the Pop-up Body:
8.
From underneath the sink, screw the
bottom gasket (1) and nut (2)
assembly onto the pop-up body (3)
by twisting clockwise until secure.
2
SPECIFICATIONS
5
1
3
6
7
8
www.homewerksww.com
2
3
4
1
2
2
1
3
1
2