Picture Tube Removal - Sony Trinitron KV-2199XDK Service Manual

2-8. PICTURE TUBE REMOVAL

3 F board
4 C3 board
7 Neck assy
5 Deflection yoke
6 Four screws
(Tapping screws)
1 Anode cap
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
REMOVING PROCEDURES
2 A board
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
Cushion
3 When one side of the rubber cap is separated from the anode button, the anode-cap
1 Do not damage the surface of anode-caps with sharp shaped objects.
2 Do not press the rubber too hard so as not to damage the inside of anode-cap.
3 Do not turn the foot of rubber over too hard.
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
a
a
b
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow c.
HOW TO HANDLE AN ANODE-CAP
A metal fitting called the shatter-hook terminal is built into the rubber.
The shatter-hook terminal will stick out or damage the rubber.
b
c
Anode button