Table of Contents
Advertisement
6 Start-up
4
Earth connection
5
Overheating protection
2.
Plug the mains plug into an earthed socket outlet.
◁
The plug socket must be freely accessible at all
times.
6
Start-up
6.1
Setting the hot water temperature
4
3
2
1
6
1
Temperature selector
knob
2
Setting ring for the
temperature
3
Adjustment spindle
Warning.
Risk of being scalded by hot water
There is a risk of scalding at the hot water
draw-off points if the temperatures are
greater than 60 °C. Young children and
elderly persons are particularly at risk, even
at lower temperatures.
▶
Select the hot water temperature so that
nobody is at risk.
1.
Select a moderate set target temperature.
8
6
Heating coil
5
4
Notch for the setting at
80 °C
5
Notch for the setting at
40 °C
6
Notch for the setting at
60 °C
◁
You can set the target temperature to either 40 °C,
60 °C or 80 °C.
2.
Remove the temperature selection knob (1).
3.
Remove the adjusting ring (2) for the temperature se-
lection knob.
Conditions: Limiting the temperature to 40 °C
▶
Slide the recess (5) for the setting ring onto the nose of
the temperature selection knob.
Conditions: Limiting the temperature to 60 °C
▶
Slide the recess (6) for the setting ring onto the lug of
the temperature selection knob.
Conditions: Limiting the temperature to 80 °C (factory setting)
▶
Slide the recess (4) for the setting ring onto the nose of
the temperature selection knob.
4.
Fit the temperature selector knob with the setting ring
onto the adjusting spindle (3).
6.2
Switching on
1.
Ensure that the direct electric domestic hot water cylin-
der has been filled.
2.
Insert the mains plug into the wall socket.
3.
Set the temperature selector knob to (E).
◁
The indicator light lights up. It goes out as soon as
the set target temperature is reached.
6.3
Handing the product over to the operator
Explain to the operator how the safety devices work and
where they are located.
Inform the operator how to handle the product. Answer any
questions the operator may have. In particular, draw atten-
tion to the safety information which the operator must follow.
Inform the operator of the necessity to have the product
maintained according to the specified intervals.
Pass all of the instructions and documentation for the
product to the operator for safe-keeping.
7
Troubleshooting
7.1
Contacting your service partner
If you contact your service partner, you should, where pos-
sible, specify the type of fault that has occurred.
7.2
Procuring spare parts
The original components of the product were also certified
by the manufacturer as part of the declaration of conformity.
If you use other, non-certified or unauthorised parts during
maintenance or repair work, this may void the conformity of
the product and it will therefore no longer comply with the
applicable standards.
We strongly recommend that you use original spare parts
from the manufacturer as this guarantees fault-free and safe
operation of the product. To receive information about the
available original spare parts, contact the contact address
provided on the reverse of these instructions.
Installation and maintenance instructions eloSTOR plus 0020244342_01
Advertisement
Table of Contents
