Nokia RM-482 User Manual page 99

directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
WLAN security mode — Select the encryption used:
•
WEP, 802.1x, or WPA/WPA2. (802.1x and WPA/WPA2 are
not available for ad hoc networks.) If you select
network, no encryption is used. The WEP, 802.1x, and
WPA functions can be used only if the network supports
them.
Use access point — Select After confirmation
•
device to ask for confirmation before the connection using
this access point is created or Automatically
device to connect to the destination using this access point
automatically.
To enter the settings for the selected security mode, select
WLAN security settings.
Advanced WLAN settings
Select Options Advanced settings and from the
>
following:
IPv4 settings — Enter the IP address of your device, the
•
subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
IPv6 settings — Define the type of DNS address.
•
Ad-hoc channel (only for ad hoc networks) — To enter a
•
channel number (1-11) manually, select
Proxy server address — Enter the address for the proxy
•
server.
Proxy port number — Enter the proxy port number.
•
Cyan Cyan
Packet data (GPRS) settings
Select Menu Ctrl. panel
>
Packet data.
Your device supports packet data connections, such as GPRS
Open
in the GSM network. When you are using your device in GSM
and UMTS networks, it is possible to have multiple data
connections active at the same time; access points can share
a data connection, and data connections remain active, for
to set the
example, during voice calls.
To define the packet data settings, select
to set the
connection and When available
the packet data network when you switch the device on in a
supported network, or
to a packet data network only when an application or action
attempts to establish a packet data connection. This setting
affects all access points for packet data connections. To use
the device as a packet data modem for your computer, select
Access point, and enter the access point name provided by
your service provider. To use a high-speed data connection,
select High speed packet access
WLAN settings
SelectMenu Ctrl. panel
>
Wireless LAN.
User defined.
To have an indicator displayed when there is a wireless LAN
(WLAN) available in your current location, select
availability > Yes.
To select the interval for your device to scan for available
WLANs, and to update the indicator, select
networks. This setting is not available unless you select
Show WLAN availability
Magenta Magenta Yellow Yellow Black Black
Settings and Connection
> >
Packet data
to register the device to
When needed to register the device
> Enabled.
Settings and Connection
> >
Show WLAN
Scan for
> Yes.