Nokia RM-482 User Manual page 98

To change the priority order of access points within a group,
scroll to an access point and Options Organise
>
priority.
Packet data access points
Select Menu Ctrl. panel Settings and
> >
Destinations Access point, and follow the instructions
>
on the display. Or, open one of the access point groups, select
an access point marked with , and select Edit.
Use the instructions provided by your service provider to edit
the following:
Access point name — The access point name is provided
•
by your service provider.
User name — The user name may be needed to make a
•
data connection, and is usually provided by your service
provider.
Prompt password — If you want to set the device to ask
•
for a password every time you log in to a server, or if you
do not want to save your password in the device, select
Yes.
Password — A password may be needed to make a data
•
connection and is usually provided by your service
provider.
Authentication — Select Secure to always send your
•
password encrypted or Normal to send your password
encrypted when possible.
Homepage — Depending on the access point type you
•
are setting up, enter the web address or the address of the
multimedia message centre.
Use access point — Select After confirmation
•
device to ask for confirmation before the connection using
this access point is created, or Automatically
Cyan Cyan
device to connect to the destination using this access point
Change automatically.
>
Select Options Advanced settings
>
following:
Network type — Select the internet protocol type to
•
Connection
>
transfer data to and from your device. The other settings
depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address
•
of your device.
DNS addresses — Enter the IP addresses of the primary
•
and secondary DNS servers, if required by your service
provider. To obtain these addresses, contact your internet
service provider.
Proxy server address
•
server.
Proxy port number — Enter the port number of the proxy
•
server.
WLAN internet access points
Select Menu Ctrl. panel
>
Destinations Access
>
on the display. Or, open one of the access point groups, select
an access point marked with
Use the instructions provided by your service provider to edit
the following:
WLAN network name
•
Search for networks. If you select an existing network,
WLAN network mode
determined by the settings of its access point device.
to set the
Network status — Define whether the network name is
•
displayed.
to set the
WLAN network mode
•
hoc network, and to allow devices to send and receive data
Magenta Magenta Yellow Yellow Black Black
and from the
— Enter the address of the proxy
Settings and Connection
> >
point, and follow the instructions
, and select Edit.
— Select Enter manually or
and WLAN security mode are
— Select Ad-hoc to create an ad