Table of Contents
Advertisement
Available languages
Available languages
EN
5.1
NOZZLE MAINTENANCE
If there is too much pump pressure, the nozzle can
become clogged, you can feel a pulsing sensation while
you pull the gun trigger.
5.1.1 REMOVE THE NOZZLE
1. Pull back the quick-connect collar on the spray
wand.
2. Remove the nozzle from the spary wand.
5.1.2 CLEAN THE NOZZLE
1. Use a straight paper clip or cleaning tool to clean
the spray tip.
2. Flush and clean the unwanted materials out of the
nozzle with the garden hose.
3. Install the clean nozzle to the spray wand.
6
TRANSPORTATION AND
STORAGE
Disconnect the power cord before transportation and
storage.
6.1
MOVE THE MACHINE
•
Point the spray wand in a safe direction.
•
Only hold the machine with the handgrip.
6.2
STORE THE MACHINE
Make sure that the gun, the high pressure hose and
the pump are dry.
Make sure that children cannot come near the
machine.
Use a recommended pump protector to prevent cold
weather damage during storage in winter.
•
Disconnect the garden hose from machine.
•
Wind the power cord and the high pressure hose.
11
5
WARNING
WARNING
WARNING
NOTE
English
•
Clean housing and the plastic components with a
moist and soft cloth.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
replace the damaged parts.
•
tighten the bolts.
•
speak to a person of an approved service
center.
•
Store the machine in a dry, isolated and frost-free
area.
7
TROUBLESHOOTING
PROBLEM
The motor does
not start.
The machine
does not get
high pressure.
10
POSSIBLE
SOLUTION
CAUSE
The power
Set the power
switch is off.
switch to the
"ON" ( | ) posi-
tion.
You do not plug
Connect the
the power cord.
power cord to
the power sup-
ply.
Electrical outlet
Try another elec-
does not supply
trical outlet.
sufficient power.
The circuit
Let it cool, and
breaker is trip-
start the ma-
ped.
chine again.
The power
Pull the gun trig-
switch is on, but
ger.
you do not pull
the gun trigger.
The diameter of
Replace with a
garden hose is
1" (25 mm) or
too small.
5/8" (16 mm)
garden hose.
The garden hose
Make sure that
is blocked.
the garden hose
is free from
blockage.
The water supply
Open the water
is not sufficient.
suppy fully.
You do not in-
Install the nozzle
stall the nozzle
onto the spray
onto the spray
wand.
wand.
The water intake
Remove the filter
filter is blocked.
and make it
clean in warm
water.
Advertisement
Chapters
Table of Contents
