Connecting To The Chimney - Beko HCA93640SS User Manual

5 Device Installation
2x
4,8x50mm
(Figure 9)
Holding the device by its body, attach it
to the hanger screws you have previously
screwed to the wall and tighten the hang-
er screws well (Figure 9).
Secure it to the wall with two 4.8x50
screws from the mounting holes on the
interior of the device (Figure 9).

5.4 Connecting to the Chimney

(Figure 10)
1- Flap Pin Socket
2- Flap Pin
Insert the plastic pin (area number 10/2)
on the flap into the pin socket (area num-
ber 10/1) located in the motor outlet.
Then, to install the other pin on the flap,
gently flex the plug and insert it into the
other pin socket (Figure 10).
14 / EN
If you are going to use Ø 120/150 mm
plastic flue adapter, connect one end of
the pipe to this adapter, or if you will not
use it, directly to the outlet on the product.
Connect the other end of the pipe to your
chimney. When the device operates at the
highest speed, make sure that these two
connections are tight enough to be dis-
placed. Check that the flap in the flue
works when tightened with the clamp
. Install the flue connection pipe on the
outside of the adapter (Figure 11 / a). If
the connection pipe is inserted into the
adapter, air suction will not occur since
the flue valve that prevents air recycling
will remain closed (Figure 11 / b). The pipe
connection should be as short as possible
and with few bends.
A: Chimney outlet pipe
B: Anti-recycling flaps
C: Plastic chimney
The covers are closed when the device is
not working and prevents possible odors
and dusts from entering the environment.
(a)
Proper
(Figure 11)
(b)
Not proper
Hood / User Manual