Chapter 2 Connections And Setup; Tv Buttons; Initial Setup - TCL X925PRO Series Operation Manual

Chapter 2

TV Buttons

- Power button
If the batteries in your remote control are run down, you can use the button(s) on your TV set.
There is only one button on the TV set, it may work just as Power on/Standby button, or as a multi-function
controller.
You can turn on the TV by press
While the TV is on, press the
use the multi-function menu, please refer to the figure below.
CH+
Standby
Tips: Short click to change, long click to select.
• Press to move the highlight to the next function selection
• Press and hold the button for more than 2 seconds to confirm your selection.
Note:
You can follow the on-screen guide to operate.
Figures and illustrations are provided for reference only and may vary depending on the model.
ON
- MIC button
OFF
The MIC button is located next to the power button. If you want to use the feature of hands-free TV voice control,
turn on this switch.

Initial Setup

The first time you switch the set on, the Welcome wizard appears, which guides you through the initial setup
process. Follow the on-screen instructions to finish the initial setup process such as selecting the language, pairing
your remote, connecting to the network, and more. During each step, either make a choice or skip the step. If you
skip a step, you can perform the setup later from the settings menu.
Notes:
- It's recommended to select Set up Google TV and finish its setup to enjoy more features during the initial setup process.
If you have finished basic TV's setup, you can reaccess Google TV by pressing
(Settings) > Set up Google TV and pressing OK to confirm.
- When you pair your remote, keep the remote control and TV within 1 meter, and follow the on-screen guide for
pairing. After finishing pairing the remote, you can use the Google Assistant button. If you skip remote pairing, you
will be prompted to pair the remote with the TV again when you use the Google Assistant button for the first time.
button on the TV.
button to display the multi-function menu. For more information about how to
CH- Volume+ Volume-
Connections and Setup
Source OK
on the remote control, selecting
4