Table of Contents
Advertisement
en Troubleshooting
Noise
Fault
Rushing, hissing noise.
Loud noises during the spin
cycle.
Banging noises, rattling in
the drain pump.
Slurping, rhythmical suction
noise.
Problem with results
Fault
Creasing.
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
52
Cause
Water is flushed under pres-
sure into the detergent
drawer.
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Foreign bodies have got into
the drain pump.
The drain pump is active, the
detergent solution is
pumped out.
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
Too much detergent/fabric
softener in the detergent
drawer.
A low spin speed is selected.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
Troubleshooting
Not a fault – normal operating
▶
noise.
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
→ "Cleaning the drain pump",
▶
Page 42
Not a fault – normal operating
▶
noise.
Troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 24
When dosing liquid detergent and
▶
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the Spin programme.
▶
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Advertisement
Table of Contents
