Frigidaire PLEW30S3DCB Installation Instructions Manual page 3

27" & 30" WARMER DRAWER INSTALLATION INSTRUCTIONS
B. Installation for a coutout height of 9¼ (23.5 cm)
1. Locate the 2 anti-tip brackets and the 2 front
supports supplied as shown on figure 3. Fix them
using the 4 black head screws (10-16 X 1¼")
supplied
2. Install the 4 spacers (Figure 4) supplied under drawer
as shown in figure 5 using the 4 screws (10-24 X
Install two spacers on each side of drawer.
3. Slide the drawer into the cutout opening until the
front frame of the drawer is flush against the
cabinet. Be careful not to pinch the electrical cord.
4. Remove the drawer as instructed in the Use & Care
Guide and secure the drawer housing to the cabinet
using the 2 black head screws (8-18 X ½") supplied
(see Figure 2). Do not overtighten screws.
5. The 60" (152 cm) appliance power cord can now be
connected into the 120 Volt outlet.
6. Proceed with mounting the built-in oven above the
drawer (if applicable). Follow the installation
instructions provided with the built-in oven. Make
sure to use the anti-tip brackets supplied with the
built-in oven.
Anti-tip Bracket
Front Support
14"
(35.6 cm)
7" (17.8 cm)
12 21 / "
32
(32.15 cm)
Figure 3
5
/
refer to B
on page 2
Center
Line
24" (64.3 cm) Max.
23 5 / " (60 cm) Min.
8
").
8
Use the screws supplied to fix
the drawer support
3
SPACER
SCREW
Figure 4
SPACER
Figure 5