Download Print this page

Frigidaire PLEW30S3DCA Installation Instructions Manual

Frigidaire plew30s3dca warmer drawer: installation instruction
Hide thumbs

Advertisement

WARMER DRAWER INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
GENERAL INFORMATION
The Warmer Drawer can be used:
As a stand alone appliance
As a combination Warmer Drawer with a 30" (76 cm) built-in oven mounted above
IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45 Kg).
NOTE: A 60" (152 cm) long cable is supplied with the
Warmer Drawer.
Stand Alone Installation
C
B
F
D
E
Minimum distance to floor
41/2" (11,4 cm)
A. HEIGHT
B. WIDTH
10" (25,4 cm)
30" (76,2 cm)
D. CUTOUT
HEIGHT
8 3/ 8" (21,3 cm)
Min.
8 5/8" (21,9 cm)*
Max.
* Note: It is also possible to install this warmer drawer in a
height opening of 9¼" (23.5 cm). Please refer to page 3
for complete instructions.
Printed in United States
Warmer Drawer Dimensions
60" (152 cm)
Cord
Warmer Drawer
A
Warmer Drawer
Cutout
FLOOR
C. DEPTH
23 3/ 8" (59.4 cm)
E. CUTOUT
F. CUTOUT
WIDTH
DEPTH
28 1/ 2 " (72,4 cm)
24" (61 cm)
28 3/4 " (73 cm)
IMPORTANT: The Warmer Drawer runs off a single
phase three-wire 120 volt, 60 hertz, AC only electrical
supply with ground.
Combination Warmer Drawer/
30" (76 cm) Built-in Oven Installation
Caution: Two 3" (7,6 cm) wide X 3/
4" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds. (90,7 Kg)
29½"
(74.9 cm)
A
B
H* =10-1/8" (25.7 cm) Min. is a Critical
dimension and must be applied.
A. HEIGHT
10" (25,4 cm)
30" (76,2 cm)
D. CUTOUT
E. CUTOUT
HEIGHT
Min. 8 3/8" (21,3 cm) 28 1/2 " (72,4 cm) 24" (61 cm) 1 1/2" (3,8 cm)
Max. 8 5/ 8" (21,9 cm)
28 3/ 4 " (73 cm)
1
E
F
G
D
C
B. WIDTH
C. DEPTH
23 3/8" (59.4 cm)
F. CUTOUT
G. HEIGHT
WIDTH
DEPTH
Depends on critical
dimension H
P/N 318201804 (0412) Rev. C
English – pages 1-4
Español – páginas 5-8
Français – pages 9-12
H*

Advertisement

loading

  Related Manuals for Frigidaire PLEW30S3DCA

  Summary of Contents for Frigidaire PLEW30S3DCA

  • Page 1 As a combination Warmer Drawer with a 30" (76 cm) built-in oven mounted above IMPORTANT: The warmer drawer must be installed on a surface leveled from left to right, rear to front and the surface must be capable of supporting 100 pounds (45 Kg).
  • Page 2: Important Safety Instructions

    WARMER DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all the instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from the appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances.
  • Page 3 WARMER DRAWER INSTALLATION INSTRUCTIONS B. Installation for a coutout height of 9¼ (23.5 cm) 1. Locate the 2 anti-tip brackets and the 2 front supports supplied as shown on figure 3. Fix them using the 4 black head screws (10-16 X 1¼") supplied 2.
  • Page 4 WARMER DRAWER INSTALLATION INSTRUCTIONS NOTES...
  • Page 5 INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR LA INSTALACIÓN Y EL SERVICIO DEBEN SER EJECUTADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA EL USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA FUTURAS REFERENCIAS. PARA SU SEGURIDAD: No almacene o use gasolina u otros vapores y líquidos combustibles cerca a éste o a cualquier otro electrodoméstico.
  • Page 6: Instrucciones Importantes De Seguridad

    INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR Notas importantes para el instalador 1. Lea todas las instrucciones de instalación antes de instalar el electrodoméstico. 2. Retire todos los materiales de empaque del electrodoméstico antes de conectar la fuente de energía. 3.
  • Page 7 INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR B. Instalación del cajón calentador con una abertura de 9¼ (23.5 cm) 1. Localice los 2 brackets anti-volteo y los 2 apoyos anteriores suministrados como mostrado en la figura 3. Instále los usando los 4 tornillos negros (10-16 X 1¼") suministrados. 2.
  • Page 8 INSTRUCCIONES DE INSTALACIÓN PARA EL CAJÓN CALENTADOR NOTAS...
  • Page 9 9¼" (23,5 cm). S'il vous plaît référez-vous à la page 11 pour des instructions complètes. Imprimé aux États-Unis Warmer Drawer Dimensions IMPORTANT: Le tiroir-réchaud fonctionne seulement avec un circuit électrique mis à la terre à 3 fils de 120 volts, monophasé, 60 Hz CA.
  • Page 10: Sécurité Importantes

    INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD Notes importantes à l’installateur 1. Lisez toutes les instructions d’installation avant de procéder à l’installation de cet appareil. 2. Retirez tout le matériel d’emballage de l’appareil avant de brancher l’alimentation électrique. 3. Observez tous les règlements et codes locaux applicables. 4.
  • Page 11 INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD B. Installation pour une hauteur de découpage de 9¼ (23.5 cm) 1. Localisez les 2 supports anti-bascules et les 2 supports frontaux fournis comme indiqués à la figure 3. Fixez-les à l'aide des 4 vis à noires fournies (10-16 X le 1¼ ») 2.
  • Page 12 INSTRUCTIONS D’INSTALLATION POUR LE TIROIR-RÉCHAUD NOTES...