Advertisement
Available languages
Available languages
PREPARE THE HOOD
3
Remove
®
Teflon
-coated
bottom cover
from hood. Set
cover and
mounting screws
aside.
Teflon
®
is a registered
trademark of DuPont.
TEFLON
4
Remove
Damper/Duct
Connector
from inside
the hood. Set
connector
aside - with
mounting
screws and
parts bag.
DAMPER/
DUCT
CONNECTOR
5
Remove
either top or
back wiring
knockout and
install
approved
Electrical
Cable Clamp.
Non-Ducted Installation - Skip to Step 15.
The following
Steps (6 thru
14) are for
DUCTED
INSTALLATION
ONLY.
6
Remove Light Panel - held in place with (3) #8 screws and
(2) #8 screws. Disconnect light assembly wire harness
(white connector).
®
-COATED BOTTOM COVER
(Held in place with 2 screws)
ELECTRICAL CABLE CLAMP
(3) #8 SCREWS
(2) #8 SCREWS
PREPARE THE HOOD
7
Remove Air
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires.
8
Remove Baffle
from air chute.
9
Rotate baffle.
Reinsert baffle into
air chute (as
shown) so that
LIGHT
baffle tabs fit all the
PANEL
way into slots in air
chute. An audible
"click" will be heard
when fully installed.
This will close off
the air flow through
the non-ducted
slots on top of
hood.
10
Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between support fin and light panel.
3
AIR CHUTE
BAFFLE
BAFFLE
TABS
SLOTS
SUPPORT FIN
Advertisement
