Advertisement
4. MODE: Press the MODE
Z
Sleep
mode.The mode is displayed on the LED screen.
Z
5. OSC: Press the OSC
stop the oscillation, press the button again. The maximum angle is 70°.
6. ION: The Ionic function can only be selected from the remote controller. Press ION
buttom to operate with ionic air purifying function.
The ION icon will be shown on the LED screen.
7. TIMER: Press the TIMER
12 hours intervals, from 1 hour to 12 hours.
8. Power save mode : when the 'Sleep' mode
LED display screen and blue light of fan will be off after 30 seconds, and you can press
buttons keys to turn on the display again.
9. Blue light: When the fan is ON, the light will switch ON. Press and hold the "SPEED"
button for 3 seconds, the light will turn to OFF. Press and hold the "SPEED"
for 3 seconds again, the blue light will turn to ON (This function cannot be activated by
the remote controller) .
Remote Controller:
1. Remote controller can be stored at the back storage
slot of the fan body.
2. Before using the remote controller, remove the plastic
protection from the battery.
3. All the functions performed on the Remote Controller work
identically to the main Control panel (except ionic function
and switch on and off of the blue light on SPEED button).
4. The remote controller uses the battery(One battery of: CR2025 is included).
FILFTER CLEAN & ASSEMBLY
1.
Always disconnect the fan from the mains by switching it off and
removing the plug from the power outlet before cleaning.
2.
Do not allow water to penetrate into the motor during cleaning.
3
Use only a soft or slightly damp cloth to clean the appliance, use a
soft brush to clean the air inlet. Never use solvent or abrasives. Do
not use very wet substances, liquids or cloths to prevent water
entering into the appliance and irreparably damaging it.
4.
Clean the air inlet grille cover, filter and air outlet grilles regularly with
a vacuum cleaner if it is used frequently.
5.
To clean the filfter, gently remove the two screws in front of air inlet
button to set the Fan as Normal
button to allow the Fan to oscillate the wind direction. To
button to set the desired auto power off time. There are
4
Z
or the 'Timer'
Z
, Natural
, or
setting is ON, the main
button
Advertisement
