Electrolux EUC2244AOV User Manual page 12

12 www.electrolux.com
Problem
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
7.2 Closing the door
1. Clean the door gaskets.
Possible cause
This is normal, no error
has occurred.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The "FastFreeze mode"
is switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
The "FastFreeze mode"
is switched on.
There is no cold air circu‐
lation in the appliance.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Solution
The compressor starts after
a period of time.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FastFreeze
mode" manually, or wait until
the mode resets automatical‐
ly to set the temperature.
Refer to "FastFreeze mode".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Open the door only if neces‐
sary.
Refer to "FastFreeze mode".
Make sure that there is cold
air circulation in the appli‐
ance.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.