Assembly; Operation - Ryobi OP407 Operator's Manual

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the following purpose:
 Charging RYOBI 40 Volt lithium-ion batteries
NOTICE:
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
KEY HOLE HANGER
To mount the charger, only use the key hole hanging feature.
The charger can be mounted horizontally or vertically. To
mount horizontally, screws should be installed so that the
center distance is 4 in. (101.77 mm). To mount vertically,
screws should be installed so that the center distance is
8 1/8 in. (206 mm).
NOTE: Use ONLY the key hole hangers when mounting this
charger on the wall. DO NOT hang from handle.
CHARGING
See Figure 1, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.

OPERATION

Charge time varies and is dependent upon the amp hour
capacity of battery pack.
NOTE: Charger charges batteries one at a time; charger does
NOT charge multiple batteries simultaneously.
 Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
 Connect the charger to a power supply.
 Attach the battery pack to the charger by aligning the
raised ribs on the battery pack with the grooves in the
charger, then slide the battery pack onto the charger.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
 Latches should snap into place to ensure charger is
correctly connected.
 Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature.
 The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
 After charging is complete, the charger's green LED will
turn off after 10 minutes.
 To remove the battery pack from the charger, depress
latches and pull up on the battery pack.
 Fan will make a slight humming noise when the battery
is charging.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the orange
LED will be on and the green LED will be off. When the battery
pack cools, the charger will automatically begin charging.
4 — English