Subscribe to Our Youtube Channel
Related Manuals for Hitecsa TH-TUNE
Summary of Contents for Hitecsa TH-TUNE
- Page 1 TH-TUNE PACKAGED AIR-AIR AND WATER-AIR UNITS USM_TH-TUNE Aire-Aire y Agua-Aire_207960_181005_EN...
- Page 2 Thank you for trusting the Hitecsa Products. Our company has been offering the market an extended range of specialized equipment for air conditioning and cooling installations for over 35 years. Our approach is based on efficiency, flexibility and on practical solutions.
-
Page 3: Table Of Contents
ELECTRICAL CONNECTIONS ....................5 POWER SUPPLY ......................... 5 CONNECTIONS ........................5 OPERATION MANUAL ...................... 6 DISPLAY ..........................6 ON-OFF CONTROL ......................6 TEMPERATURE ADJUSTMENT ................... 6 Th-tune internal temperature probe calibration SYSTEM MODES ........................ 6 ......................6 NDOOR ODES ......................... 7 IME SCHEDULING Examples of time programming .................. -
Page 4: Installation Instructions
TH-TUNE Packaged Air-Air and Water-Air units INSTALLATION INSTRUCTIONS USM_TH-TUNE Aire-Aire y Agua-Aire_207960_181005_EN... -
Page 5: Electrical Connections
Maximum length = 500 m. If the “Cn” message does not disappear from the TH-Tune display, it means that communication between the thermostat and the control board has failed (possible reasons: wrong connection to the terminals, the “Rx/Tx+” and the “Rx/Tx-“... -
Page 6: Operation Manual
Access to the configuration menu with the “22” password and press to validate. Rotate the central button until the PCAL option appears and select it. Be careful when changing any other parameter from this menu! That might disable the Th-TUNE. Turn the central button to modify the correction value and press to validate. -
Page 7: Time Scheduling
TH-TUNE Packaged Air-Air and Water-Air units OPERATION Time scheduling Keep the button “ ” pressed for at least 3 seconds until “ ” appears (if the Clock stated hour is not correct you can change it here): turn the central button and chose “Time band”... -
Page 8: Warning And Information Signals
Packaged Air-Air and Water-Air units OPERATION Warning and Information signals Some 4-letter alphanumeric characters (AL01) may be displayed on the TH-Tune screen. When the ( ) symbol also appears then it is an alarm, otherwise it is a warning or an information signal. The warnings disappear automatically when the cause disappears while the alarms will have to be reset. -
Page 9: Alarm Codes Description
TH-TUNE Packaged Air-Air and Water-Air units OPERATION Alarm Codes Description CODE DESCRIPTION FIELD AL01 Alarm probe B1 disconnected (Outdoor Temperature) General AL02 Alarm probe B2 disconnected (Air supply Temperature) General AL03 Alarm probe B3 disconnected (Comp. 1 discharge Temperature) General... -
Page 10: Description Of The Modbus Parameters
Proceed to enabling the communication with a PGD or a Mini PGD terminal so as to be able to change the MODBUS parameters from the TH-TUNE terminal: Enable the supervisor in the factory level menu and enable Start / Stop of the unit through supervisor. - Page 11 TH-TUNE Packaged Air-Air and Water-Air units Subject to modification without prior notice.Translated from the original manual in Spanish. USM_TH-TUNE Aire-Aire y Agua-Aire_207960_181005_EN...
Need help?
Do you have a question about the TH-TUNE and is the answer not in the manual?
Questions and answers