INSTALLATION INSTRUCTIONS Separate the terminal front panel from the back panel by pressing the blockage tab located at the top of the thermostat case. Remove the back panel. In order to fasten the back panel to the wall, align it on the wall. Install 3 fixing screws through the mounting holes.
MICRO SWITCH DIP ADJUSTMENTS ATTENTION ! MICRO SWITCH DIP ADJUSTMENTS ARE SET AT THE FACTORY SWITCH S1 Fan in economy mode Compressor time delay Modes Window contact Heating pump or Change to 4 min, Without System shut Fan auto Fan always on Cooling only Cooling with economy...
OPERATION INSTRUCTIONS SWITCH ON / SWITCH OFF Press (ON/OFF) button to switch ON or switch OFF the thermostat. − The words "ON" or "OFF" will be displayed on the screen. − TEMPERATURE ADJUSTMENT Adjust the SET POINT temperature using the buttons (+) or (–). −...
FAN / AUTOFAN VENTILATION Press again the “FAN” button. Use the (+) or (–) buttons to select the automatic fan mode: Fan in auto mode The screen will display The screen will display “Auto Fan” on the screen. The fan will operate only −...
Page 7
Fax. +34 93 893 96 15 Fax. +34 93 893 96 15 08800 Vilanova i la Geltrú 08800 Vilanova i la Geltrú Barcelona, Spain Barcelona, Spain www.hitecsa.com www.hitecsa.com The technical data and colours of our prod roducts are subject to change without prior notice.