Location Of Controls - JVC LT-32G3 Instructions Manual

Location of controls

1 (LT-24...)
Description of Indicators and Controls
1. Remote sensor
2. VOL+/–/◀/▶ buttons: To control volume / In Menu: Setting.
3. CH / /▲/▼ buttons: Press
to change to a lower numbered channel set into memory. In Menu: Setting.
4. MENU button: To display the menu screen.
5. INPUT/ENTER button: Select input mode. Press INPUT/ENTER. Then press ▲/▼ to select input
source. In Menu : Using as ENTER button.
6. (Power)-button: Preparation: Connect AC Cord to AC110~240V, 50/60Hz.
a) If standby-LED is red, you may power-off. To power-off, press power-button 1x and release.
For confirmation, standby-LED will change to dark. Power-on by remote control is not available.
b) If standby-LED is off, you may power-on. To power-on, press power-button 1x and release.
For confirmation, standby-LED will change to blue.
7. (Standby/On) indicator: The LED indicator lights up red in standby mode, and blue in the power
ON mode.
8. Loudspeakers
For complete disconnection from the network, remove the supplied AC Cord from the socket.
To adjust the TV angle (LT-42.../LT-46...) :
You can adjust the TV angle of the TV-screen for 30° from horizontal angle. Hold the base of the TV while
adjusting the angle.
LT-32...
8
2
to change to a higher numbered channel set into memory. Press
7 1
3 4 5 6
5