Dyna-Glo DGA480SSN Manual page 13

ASSEMBLY INSTRUCTIONS
14. Remove the igniter cap by turning it counter-
clockwise. Insert the AA battery (L) into the
igniter body with Positive (+) end facing out.
Replace the igniter cap.
CONNECTING THE GRILL TO THE NATURAL GAS SUPPLY
• The quick disconnect socket (A1) and supply gas line must be installed by a qualified service agency.
The supply connection must be made in accordance with local codes or, in the absence of local codes,
with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, in the USA, or the Natural Gas and
Propane Installation Code, CSA B149.1, in Canada.
• A properly sized manual shutoff valve must be installed between the grill and the gas supply piping.
• The grill and its individual shutoff valve must be disconnected from the gas supply piping system
during any pressure testing of that system at test pressures in excess of 0.5 PSI (3.5 kPa).
• The grill must be isolated from the gas supply piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply piping system at test pressures equal to or less
than 0.5 PSI (3.5 kPa).
• Always connect the flexible gas supply hose to the gas supply before opening the manual shutoff valve.
TO CONNECT:
1. Ensure that the manual gas shutoff valve is closed.
2. Remove the protective rubber caps from the plug
and sleeve ends of the quick disconnect fittings.
Check that the fittings are clean.
3. Retract the sleeve on the coupling as illustrated.
4. Insert the plug and release the sleeve as illustrated.
5. Push the plug into the sleeve until the sleeve snaps
forward to lock the plug in the coupling.
6. Open the manual gas shutoff valve.
TO DISCONNECT
1. Close the manual shutoff valve.
2. Push the sleeve back and gently pull out the plug.
3. Replace the protective rubber caps on the plug and sleeve ends of the quick disconnect couplings.
14
13
L
A1