Installation Warnings; Electrical Information (For Uk Type Plug) - Bush BUCL6082 Instruction Manual

Installing your
Bringing it all together

Installation warnings

Before using your fridge for the first time, please
pay attention to the following points:
• The operating voltage for your fridge is 220-
240 V at 50Hz.
• The plug must be accessible after installation.
• Your fridge may have an odour when it is
operated for the first time. This is normal and
the odour will fade when your fridge starts to
cool.
• Before connecting your fridge, ensure that
the information on the data plate (voltage
and connected load) matches that of the
mains electricity supply. If in doubt, consult a
qualified electrician.
• Insert the plug into a socket with an efficient
ground connection. If the socket has no
ground contact or the plug does not match,
we recommend you consult a qualified
electrician for assistance.
• The appliance must be connected with a
properly installed fused socket. The power
supply (AC) and voltage at the operating point
must match with the details on the name
plate of the appliance (the name plate is
located on the inside left of the appliance).
• We do not accept responsibility for any
damages that occur due to ungrounded
usage.
• Place your fridge where it will not be exposed
to direct sunlight.
• Your fridge must never be used outdoors or
exposed to rain.
• Your appliance must be at least 50 cm away
from stoves, gas ovens and heater cores, and
at least 5 cm away from electrical ovens.
• If your fridge is placed next to a deep freezer,
there must be at least 2 cm between them
to prevent humidity forming on the outer
surface.
• Do not cover the body or top of fridge with
lace. This will affect the performance of your
fridge.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions.
14 Installing your
Built Under Larder
Built Under Larder
• Clearance of at least 150 mm is required
at the top of your appliance. Do not place
anything on top of your appliance.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly before use
(see Cleaning and Maintenance).
• Before using your fridge, wipe all parts with
a solution of warm water and a teaspoon of
sodium bicarbonate. Then, rinse with clean
water and dry. Return all parts to the fridge
after cleaning.
• The installation procedure into a kitchen
unit is given in the installation manual. This
product is intended to be used in proper
kitchen units only.
Electrical information (For UK type
plug)
Warning! This appliance must be earthed.
The mains lead of this appliance has been fitted
with a specially earthed plug.
Important: Do not use the appliance
without the fuse cover in position. Should the fuse
need to be replaced, it must be replaced with a
13A fuse, ASTA approved to BS1362.
The plug must be used with a specially earthed
socket of 13 amperes. If there is no such socket
in your house, please have one installed by an
authorised electrician.
The mains lead of this
appliance has been fitted
with a BS 1363A 13A fused
plug. To change a fuse in
this type of plug, follow
the steps below:
1. Remove the fuse cover
and fuse.
2. Fit replacement 13A
fuse, ASTA approved to BS 1362 type, into the
fuse cover.
3. Replace fuse cover.