RSA. These items may need to be removed or repositioned for proper RSA installation. Step 2: Place the RSA-180 over the outer edge of the escutcheon and ensure that the device sits flush against the panel. Engage the two twist-lock magnets by turning the handles of each 180°...
Page 3
Next, insert the clip through the rod-end and clevis and press the fitted end of the clip over the clevis to secure the linkage in place. The RSA-180 is now properly installed and ready for operation. RSA-180 Installation and Operation...
Please ensure the rotation of the motor is fully operating the handle in both the “UP” and “DOWN” directions, adjust the hard stops as necessary to achieve this result. Page | 4 RSA-180 Installation and Operation...
Page 5
RSO-III faceplate to open the breaker. ATTENTION! For any questions pertaining to the operation of the RSO-III, or more detailed RSO-III instructions, please see the manual that was included with the RSO-III. RSA-180 Installation and Operation Page | 5...
Page 6
3.0 Components RSA-180 Component List CBS ArcSafe® Item Description Part Image RSA-180 Assembly Charging Handle Adapter Page | 6 RSA-180 Installation and Operation...
Page 7
Federal, State, Local, and In-house safety regulations and procedures. Attention should be given to distance, angle, and personal protective equipment (PPE). RSA-180 Installation and Operation Page | 7...