Page 1
B E T W E E N Y O U A N D Gainesville, Texas 76241 A R C - F L A S H D A N G E R ? ® Copyright CBS ArcSafe 2019 Printed in the United States of America 2616 Sirius Road...
Page 2
RRS-4 – PLC Based Universal Remote Racking System (Rotary) The CBS ArcSafe® RRS-4 universal remote racking system is an updated PLC based version of the best selling RRS-1. The dual mode, source programmable, PLC based control system offers two different operating modes to choose from based on user preference or the application.
2. Note the position of the switch handle and manually position the motor arm of the RSA-184F to match. 3. Place the RSA-184F on the face of the switch ensuring that the motor arm properly fits over the switch arm and that the magnets are flush with the face of the switch.
Page 4
4. Secure the RSA-184F to the switch by turning the handles of the two magnets 180 degrees clockwise. 5. The RSA-184F is ready for remote operations. RSA-184F Installation and Operation...
5. Ensure that the Auto Retract (AR) function is set according to the placard on the RSA. If not specified, leave AR turned OFF. 6. Press and hold CLOSE to turn ON the breaker. 7. Press and hold TRIP to turn OFF the breaker. RSA-184F Installation and Operation...
The motor can be repositioned vertically to ensure a proper fit over the switch arm. 1. Loosen the four bolts securing the motor bracket to the frame. 2. Slide the motor bracket up or down to position the motor arm. 3. Re-tighten the four bolts. RSA-184F Installation and Operation...
Page 7
3.2 Magnet Adjustment The magnets on the RSA-184F can be moved laterally and vertically to avoid any obstacles on the switch. 1. Loosen or remove the bolts on the magnet to be adjusted. 2. Reposition the magnet as necessary. 3. Re-insert and re-tighten the bolts to secure the magnet.
Page 8
8. Rotate the motor arm by hand to match the switch arm. 9. Slide the upper hard stop to contact the arm at that position. 10. Tighten the hard stop bolt. 11. Repeat with the switch in the off position using the lower hard stop. RSA-184F Installation and Operation...
Page 9
Notes RSA-184F Installation and Operation...
Page 10
Notes RSA-184F Installation and Operation...
Page 12
RSA-184F Installation and Operation 2616 Sirius Road Denton, TX 76208 Tel: 877-4-SAFETY Fax: 940-382-9435 Website: www.CBSArcSafe.com Email: info@CBSArcSafe.com ANGER Ensure that personnel using this equipment are adequately trained in the operation of the switchgear they are planning to work with; that they are correctly stationed outside the arc flash boundary;...