Attaching The Hose - Black & Decker BDH1855SM Instruction Manual

attachInG a cLeanInG Pad - fig. f
replacement cleaning pads are available from your
Black+Decker dealer (cat. no. SMP20).
• Place a micro-fiber cleaning pad (6) on the floor with
the 'hook & loop' side facing up.
• Press steam mop down onto the cleaning pad. You
are now ready to steam clean and sanitize your floor.
notIce:
Do not store with a wet pad as this can
damage your floor. always place the steam mop with the
handle (4) in the upright position when stationary and
make sure the steam mop is turned off when not in use.
reMoVInG a cLeanInG Pad - fig. G
cautIon:
changing the cleaning pad on your steam mop. Do not
wear slippers or open-toed footwear.
• Return the handle tube (4) to the upright position
and turn the steam mop 'OFF'.
• Wait until it cools down. (approximately five minutes)
• Place the front of your shoe onto the cleaning pad
removal tab (14) and press down firmly.
• Lift the steam mop up off the cleaning pad.
notIce:
Do not store with a wet pad as this can
damage your floor. always place the steam mop with
the handle (4) in the upright position when stationary and make sure the steam mop is
turned off when not in use.
fIttInG a scent Pack - fig. h
return the handle (4) to the upright position and turn
the steam mop 'OFF'. Wait until the steam mop cools
down. (approximately five minutes).
• Slide the Fresh Scent door release button (7), the
door will open.
• Place the Fresh Scent tab into the pocket (29) as
shown in figure h2.
• Close the door (30) py pushing it firmly down until an
auidle click is heard.
notIce:
Do not store with a wet pad as this can
damage your floor. always place the steam mop with the handle (4) in the upright position
when stationary and make sure the steam mop is turned off when not in use.
hand-heLd steaM cLeaner attachMents
notIce:
First remove the hand-held steam cleaner from the steam body.

attachInG the hose

VarIaBLe noZZLe - fig. I
• Press in the clips (17) on either side of the hose (16)
or variable nozzle.
• Align the two keys on the inside flange of the hose
or variable nozzle with the two slots adjacent to the
steam nozzle on the hand-held steam cleaner or hose.
• Firmly press the hose or variable nozzle onto the
steam nozzle (18) of the hand-held steam cleaner or
hose such that it is fully seated, and release the clips.
WarnInG:
nozzle of the hose and handheld steam cleaner before
each use (figure J). If the seal is missing or damaged
contact your nearest authorized repair agent. Do not
use the appliance.
cautIon:
ensure that the hose and/or variable
nozzle is securely fastened before using the hand-held
steam cleaner.
always wear suitable shoes when
or
Inspect the seal on the steam
f
G
h1
7
I
16
J
6
h2
30
29
17
18
17
Seal