Dyna-Glo DGE486BSP Manual page 15

ASSEMBLY INSTRUCTIONS
14. Insert 1 M6x12 screw (AA) Screw and 2
M4x12 Screws (DD) to grill body (C1),leaving
4-6mm clearance from screw head to grill body
(C1). Align right side table assembly (Z) to the
3 inserted screws. Insert 3 M6x12 screws (AA)
with plain washers (BB) from the holes of grill
body (C1) out to the right side table
assembly (Z). Secure right side table assembly
(Z) using 1 M4x12 screw (DD). Adjust the
right side table assembly (Z) correctly then
tighten all screws.
Hardware Used
AA
M6x12 Screw
Plain
BB
Washer
Spring
DD
Washer
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 15.
FAILURE TO DO SO MAY
RESULT IN FIRE OR
EXPLOSION, POSSIBLY
CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
14
DD
x 4
x 3
x 3
15
C1
BB
AA
DD
AA
Z