Dual Stage Shock Sensor; Auto-Start Function; Reservation Mode - Young Shin Electronics 2WAMR User Manual

Two-way am remote
Table of Contents

Advertisement

Dual Stage Shock Sensor

Press Buttons
for 2 seconds to activate or deactivate the dual stage shock
sensor. The dual stage shock sensor will activate in 30 seconds after the CompuStar
alarm mode is armed. When the dual shock sensor is engaged, the remote-pager
will be alerted by the following triggers:

Auto-Start Function

Press button
for 2 seconds to auto-start an automatic transmission engine.
Remember, that a manual key in the ignition is required to drive the car.
For manual transmission vehicles, please use reservation mode.
Press button
for 2 seconds in order to turn off an auto-started car.
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset
options at the time of installation and then shut off.
shows the amount of run-time left in the remote
start mode.
The anti-grind circuit (an optional feature provided by your installer) prevents you
from engaging the starter on a remote-started vehicle.
Page 10
If there is a problem in auto-starting your vehicle,the Young Shin Electronics,Inc.
system will do one of two things; if it fails for any of the reasons listed in the table
below, it will flash the parkinglights three times then flash the error number.
Otherwise, it will attempt to start the vehicle three times. If, after three times, the
vehicle will not start or stay running, the Young Shin Electronics,Inc. system will shut
down. In either case, please see your installer to resolve the situation.
Error Number
(# of times parking lights flash)
1
2
3
4
5
6
7
While your vehicle is running with your key, press button
you are now in the continuation mode. Your engine will continue running for the
preset time even if you take your key out the ignition.
For a quick stop when you don't want to restart the vehicle.

Reservation Mode

In order to auto-start your manual transmission vehicle, you must first set the
Young Shin Electronics, Inc system to Reservation Mode before leaving your vehicle.
The purpose of Reservation Mode is to leave the transmission gear in the neutral
position when you leave your vehicle. Reservation mode is intended for use on
MANUAL TRANSMISSIONS ONLY and NOT FOR AUTOMATIC TRANSMISSIONS.
Reservation Mode must be engaged each and every time you leave your manual
transmission vehicle in order to auto-start it.
The system is not recommended for vehicles with removable tops.
Error Reason
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open
Reservation Off (Manual Transmission Only)
for 2 seconds,
(manual transmission only)
Page 11

Advertisement

Table of Contents
loading

Related Products for Young Shin Electronics 2WAMR

Table of Contents