Table of Contents
Advertisement
More Button Functions
(1) Time Setting
Button
PressedFor
2 sec
STEP 1
STEP 2
1/2 sec
1/2 sec
STEP 3
1/2 sec
STEP 4
2 sec
(2) RPS & Vibration mode on or off
Button
PressedFor
STEP 1
2 sec
1/2 sec
STEP 2
1/2 sec
Step 2 must be completed within 15 seconds. If not, start over at step 1.
Function
Tones will sound for confirmation
Time setting is on. The numbers will
flash, and tones will sound.
Change hour.
Change minutes.
Time setting is off. Tones will
sound.
Function
Tones will sound for confirmation
RPS on or off, tones will sound for
confirmation.
Vibration mode on or off, tones will
sound for confirmation.
Page 8
Remote-Pager Learn Routine
The Young Shin Electronics, Inc. system will allow up to three remotes to be
programmed to one vehicle. Please perform the following procedure to add or
reprogram additional remotes.
Alarm Mode
You can arm or disarm alarm mode by pressing Button for a 1/2 second.
Press Buttons
for a 1/2second to make your car siren mute when arming or
disarming your vehicle. Keep in mind that your car siren will still activate for all
other modes (i.e. panic or alarm trigger) regardless of whether or not your car
siren is in mute mode. The car siren will be mute only when arming or disarming
your vehicle.
When the alarm is armed, the starter kill function (an optional feature provided by
your installer) is activated. This feature disengages the starter mechanism on
your vehicle and prevents it from starting, even with a key.
If you lose your remote after you have armed the vehicle, use your key
to open the door. The siren will go off. Turn the ignition on then off,
5 times with your key to shut down the alarm and put the system into
valet mode. You can cancel the valet mode with a remote later on.
See : Valet mode, on page 10.
(Siren duration is 30 to 60 sec depending on the options set at the time
of initial installation.)
Page 9
Advertisement
Table of Contents
