Sym e-Virid Manual page 11

Vehicle Lock Signal
Driving Mode
Driving Mode
Pull the brake lever then press〝
can switch:〝
〝 〞 Vehicle Lock Signal
When the main switch is turned to 〝
Signal will go off, then you can ride the scooter.
CAUTION:
After unlocking the vehicle, it will automatically transfer to lock condition if the vehicle is not
operated (without turning throttle) in 5 minutes. It is needed to pull the brake lever and press
〝 〞, to activate to vehicle again.
In the situation of unlocking the vehicle while the main stand is applied, turn the throttle and the
rear wheel go unloaded, the vehicle will go idling protection, and there will be no power output.
If the side stand is applied, the vehicle lock signal will be on, and it is unable to activate the
vehicle.
〝 〞 Normal Mode
The scooter operates at its max efficiency. The max speed is around 50km/h on level road
condition.
〝 〞 Economic Mode
The scooter operates at its most economic efficiency to carry out the best durability. The max
speed is around 30km/h.
〝 〞 Hill-climbing Mode
Hill-climbing Mode will increase the motor torsion to enhance hill-climbing ability. After 30
seconds of applying this mode, the scooter will automatically transfer to normal mode.
While used on flat road, the scooter will increase its motor torsion and increase its acceleration.
CAUTION:
If the hill-climbing mode is continuously used on flat road or gentle slope, the scooter will not transfer
to normal mode and maintain at hill-climbing mode.
While changing lanes or making a turn, do not switch the modes.
〝 〞 Energy-saving Mode
When riding on flat road condition, 〝
energy-saving state.
〞(normal mode),〝
〞,vehicle lock signal〝
〞(economic mode),〝
〞 , pull the brake lever and press 〝
〞 indicates the scooter is operated at the most
Energy-saving
Mode
〞will go off, at the mean time you
〞(hill-climbing mode).
〞 , Vehicle Lock
5. Use of Each Component
7