Table of Contents
Advertisement
eIVP-CFS-AI-D0000 AI Box
Chapter
4
4. UEFI Setup Utility
4.1 Introduction
This section explains how to use the UEFI SETUP UTILITY to configure your system. The UEFI
chip on the motherboard stores the UEFI SETUP UTILITY. You may run the UEFI SETUP UTILITY
when you start up the computer. Please press <F2> or <Del> during the Power-On-Self-Test
(POST) to enter the UEFI SETUP UTILITY, otherwise, POST will continue with its test routines.
If you wish to enter the UEFI SETUP UTILITY after POST, restart the system by pressing <Ctl> +
<Alt> + <Delete>, or by pressing the reset button on the system chassis. You may also restart by
turning the system off and then back on.
Because the UEFI software is constantly being updated, the following UEFI setup screens and
descriptions are for reference purpose only, and they may not exactly match what you see on
your screen.
UEFI Menu Bar
4.1.1
The top of the screen has a menu bar with the following selections:
Main: To set up the system time/date information
Advanced: To set up the advanced UEFI features
H/W Monitor: To display current hardware status
Security: To set up the security features
Boot: To set up the default system device to locate and load the Operating System
Exit: To exit the current screen or the UEFI SETUP UTILITY
Use
key or
key to choose among the selections on the menu bar, and then press
<Enter> to get into the sub screen. You can also use the mouse to click your required item.
20
Advertisement
Table of Contents
