Table of Contents
Advertisement
Projecting
To turn off the power
24
(EN)
1
Press the I / u key on the Remote Commander or on the control panel.
The following message appears to confirm if you want to turn off the
power.
P OW E R O F F ?
P l e a s e
p r e s s
k e y
a g a i n .
I / u
Note
The message will disappear if you press any key except the I / u key,
or if you do not press any key for five seconds.
2
Press the I / u key on the Remote Commander or on the control panel
again.
The ON indicator flashes in green and the fan continues to run for
about 90 seconds to reduce the internal heat. Also, the ON indicator
flashes quickly for the first 30 seconds. During this time, you will not
be able to turn the power back on with the I / u key.
3
Unplug the AC power cord from the wall outlet after the fan stops
running and the STANDBY indicator lights in red.
When you cannot confirm the on-screen message
When you cannot confirm the on-screen message in a certain condition,
you can turn off the power by holding the I / u key on the Remote
Commander or on the control panel for about one second.
Note
Do not unplug the AC power cord while the fan is still running;
otherwise, the fan will stop although the internal heat is still
high, leading to breakdown of the projector.
Advertisement
Table of Contents
