Table of Contents
Advertisement
How to use the adjusters
While lifting the projector, adjust the height so that the
projector becomes level.
There are one adjuster at the front and two at the rear
of the projector.
As for the front adjuster, press the front adjuster
button while lifting the projector to adjust the height.
Turn the front adjuster for fine adjustment.
Front adjuster button
Control panel
1 I / u (on / standby) key
Turns on and off the projector when the projector is in
the standby mode. The ON indicator lights in green
when the power is turned on.
When turning off the power, press the I / u key
twice following the message on the screen, or press
and hold the key for about one second.
For details on steps for turning off the power, see "To turn off
the power" on page 24 (EN).
2 INPUT key
Selects the input signal. Each time you press the key,
the input signal switches as follows:
n VIDEO IN/AUDIO IN
INPUT B N
LAMP/COVER
TEMP/FAN
!¡
0
LIGHT
9
8
PATTERN
7
APA
6
RESET
INPUT A N
As for the rear adjusters, turn them for adjustment.
To lower
the projector
Notes
• Be careful not to let the projector down on your fingers.
• Do not push hard on the top of the projector with the
adjusters out.
• Do not force the rear adjusters when you turn them.
Using too much force may result in damage.
POWER
STANDBY
SAVING
ON
+
I / u
VOLUME
–
INPUT
V
MENU
B
b
v
ENTER
Note on the VPL-X600E model
The optional IFB-X600E Interface Board is required
for VIDEO IN and AUDIO IN jacks.
3 MENU key
Displays the on-screen menu. Press again to clear the
menu.
4 Arrow keys (V/v/B/b)
Used to select the menu or to make various
adjustments.
To raise
the projector
1
2
3
4
5
(Continued)
11
(EN)
Advertisement
Table of Contents
