Table of Contents
Advertisement
Connecting 15k RGB/Component Equipment
Rear
15k RGB/component equipment
This section describes how to connect the projector with 15k RGB and
component equipment.
For details on how to connect a computer, see page 18 (EN), and to
connect a VCR and external active speakers, see page 20 (EN). Also refer
to the instruction manual of equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out from
the plug, not the cable itself.
Stereo audio
connecting cable
(not supplied)
to
RGB/component output
Notes
• Select the RGB or component signal with INPUT-A or INPUT-B in the
SET SETTING menu.
• Use the composite sync signal when you input the external sync signal
from 15k RGB/component equipment.
VIDEO IN
AUDIO IN
(MONO)
S VIDEO
VIDEO
L
R
AUDIO OUT
CONTROL S IN
PLUG IN POWER
INPUT A
INPUT B
MOUSE
AUDIO
MOUSE
SMF-402 Signal Cable (not supplied)
3X phono jack ˜ HD D-sub
15-pin (male)
or
SMF-400 Video Signal Cable (not supplied)
5X BNC ˜ HD D-sub 15-pin (male)
AUDIO
21
(EN)
Advertisement
Table of Contents
