Siemens SIPROTEC T103 Manual page 4

Applicability of this
Manual
Additional Support
Instructions and
Warnings
4
This manual is valid for
®
• SIPROTEC
4 devices 7VU683 version V4.70 and 7VU681 version V4.60
• Redundant IEC 60870-5-103 communication module version 01.01.00 or higher.
Note:
The redundant IEC 60870-5-103 module is not for all SIPROTEC
Check the manual of the device or contact your Siemens representative.
For device parameterization DIGSI
standard mappings 3-1 to 3-n (n = device type dependent number of standard map-
pings) have to be used.
Should further information be desired or should particular problems arise which are
not covered sufficiently for the purchaser's purpose, the matter should be referred to
the local Siemens representative.
The warnings and notes contained in this manual serve for your own safety and for an
appropriate lifetime of the device. Please observe them!
The following terms are used:
DANGER
indicates that death, severe personal injury or substantial property damage will result
if proper precautions are not taken.
Warning
indicates that death, severe personal injury or substantial property damage can result
if proper precautions are not taken.
Caution
indicates that minor personal injury or property damage can result if proper precau-
tions are not taken. This particularly applies to damage on or in the device itself and
consequential damage thereof.
Note
indicates information about the device or respective part of the instruction manual
which is essential to highlight.
®
4 version 4.8 or higher and IEC 60870-5-103
7VU68x Redundant T103 Bus mapping
®
devices available.
C53000-L2540-C558-1