Advertisement
6.
Operation
a.
Press switch once to turn on the grinder, and the LED1 will be
light on. The speed will be fast at the beginning and then back to
6,000 rpm as set for speed 1 after 2 seconds.
b.
Press switch twice, LED2 will be light on, and speed will change to
10,000rpm.
c.
Press switch three times, LED3 will be light on, and speed will
change to 15,000rpm.
d.
Press switch four times to turn off the grinder, and LED indicator
will be off.
e.
The grinder can be turned off by pressing the switch for 2 seconds
during operation.
7.
Accessories
Sanding bands: To be used with mandrel for
smoothing metal or plastic surfaces
Diamond bits: For fine detail work, engraving, carving, touch-up
and finishing. Use on wood, jade, ceramic, glass, hardened steel,
semi-precious stones and other hard materials. Bits are covered
with diamond particles.
Grinding stones: For surface treatment of metal parts,
cast-metal parts, welding seams and for the removal of rust.
Different shapes are available.
Engraving bits:
plastic or soft metal material.
Nylon brush: For clean dust after engraving or grinding.
For engraving and milling wood, glass fiber,
5
rough-shaping and
Advertisement
