Download Print this page

Pro'sKit PT-5205U Operator's Manual page 5

3.7v cordless mini grinder

Advertisement

2.
User Guide
Hold the tool as if you hold a pen or pencil in your hands.Please do not push
the spindle lock while using the engraver. The tool can be switched on or off,
and the speed can be set by pushing the switcher at the top of the engraver
pen
3.
Changing the Parts
a.
Turn the device off and ensure that the rotating part is stopped.
b.
Push and hold the spindle lock then turn the chuck until the button
is fully pushed in.
c.
When the rotating part is clicked in, turn the locking collar down
and pull the parts/bit out from the tool.
d.
Insert the new accessories into the chuck then fix the screw on
while pushing the locking collar
e.
Finally, release the spindle lcok.
4.
Warning!
a.
Before using the tool, ensure that it is ready and safe to use.
b.
Do not use in wet condition and enviroment.
c.
Never use the tool near to flammable gas or liquids.
d.
If the tool stops unexpectedly or appears to break down in use,
disconnect from the power supply before handling moving parts.
e.
For your protection always wear safety goggles and breathing mask,
keep fingers, hair and clothing clear of moving parts.
f.
Do not touch the drill/grinding tip during operation(even if it is in low
speed), because it can cause injury.
5.
Charging the Tool
a.
Connect the power supply (DC5V 500mA to 1000mA), insert Micro
USB into the machine.
Red light=charging
b.
Charger will automatically stop charging when it is completed. It is
ok to leave tool on charger continually
NOTE! A battery pack that has been unused for a while or never been
charged must be charged before reuse or first use.
CAUTION! Do not charge battery frequently in quick succession, which may
result in danger for overcharging the battery pack.
Green light=Charging completed
4

Advertisement

loading