Connecting The Speakers - ELAC Navis AB-51 Operating Instructions Manual

Connecting the Speakers

The Navis speakers can be connected three different ways Wired RCA Unbalanced, Wired XLR Balanced, or
Wireless (AirX²). CAUTION—THE NAVIS SPEAKERS DO NOT HAVE A VOLUME CONTROL. IF CONNECTED
DIRECTLY TO A FIXED OUTPUT SOURCE THE VOLUME WILL BE AT MAXIMUM LEVEL AND MAY DAMAGE
THE SPEAKERS AND YOUR HEARING. ONLY USE WITH VARIABLE OUTPUT SOURCES!!!
Connecting the Navis Speakers using wired (RCA or XLR) connections
1. Using an RCA or XLR interconnect cable, connect the variable pre-outputs from your pre-amplifier to the RCA/
XLR input on each speaker.
2. Select the RCA or XLR input using the source switch on the rear of the each speaker.
ELAC Navis Speakers | www.elac.com | Page 6