Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Pattern Hole
Pattern hole dimensions for milling are specified in the general dimensions
for each reference.
The milling of the furniture has to be done from below.
Attention
Manipulation of the product should be avoided, no stress should
be applied to the product except from the instructions given in
this document. Cutting, drilling, soldering, adding of electrical and
mechanical components can cause danger and should be avoided
by all mean. Not complying with these direction will result in a lost
of the Arthur Holm warranty. Albiral Display Solution S.L. shall not be
held liable for any loss or injury incurred as a result of modifications
made to goods by anyone other than the supplier or the supplier's
authorised representative without the supplier's written permission. Such
modifications shall be deemed to terminate any further guarantee
obligations.
9
Advertisement
Table of Contents
