Description & Screws
10
Before remove ASSY PCB MAIN,
Discharge Capacitors
2CNT
Before remove 3in1 board, Must discharge
capacitors for your safety.
Check discharge point(1st, 2nd block) and then,
discharge with discharge-Jig.
Service Jig-Capacitor Discharge
• If LED ON £ LED OFF discharge is
completed.
LED ON
<Before discharging>
9
Then verify voltage is less than 10Vdc across
leads with Volt Meter.
BN81-16292A
LED OFF
<After discharging>
Picture Description
Measurement point
3. Disassembly and Reassemble
Measurement point
3-7