Canon ZR400 Instruction Manual page 139

Playback
Problem
Pressing the playback button
does not start playback.
Image will not appear on the
TV screen.
Tape is running, but image will
not appear on the TV screen.
No sound from the built-in
speaker.
Editing
Problem
Dubbing via the camcorder's
DV terminal does not work.
Cause
Camcorder is turned off, or is
not set to PLAY (VCR) mode.
The TAPE/CARD switch is set
to CARD.
Cassette is not loaded.
Tape reached the end
(" END" flashes on the
screen).
[AV DV] is set to [ON].
TV/VIDEO selector on the TV
is not set to VIDEO.
Video heads are dirty.
You attempted to play back or
dub copyright protected tape.
Speaker volume is turned off.
Cause
[AV DV] is set to [ON].
Wrong signal format.
Solution
Set the camcorder to PLAY
(VCR) mode.
Set the TAPE/CARD switch to
TAPE.
Load a cassette.
Rewind the tape.
Set [AV DV] to [OFF].
Set the selector to VIDEO.
Clean the video heads.
Stop playback/dubbing.
Adjust the volume with the
SET dial.
Solution
Set [AV DV] to [OFF].
Dubbing may work via the AV
terminal.
Refer also to the instruction
manual of the connected
device.
32
E
32
16
32
81
35
132
–
34
81
–
139