Transferring Video Recordings To A Computer - Canon ZR400 Instruction Manual

Transferring Video Recordings to a
Computer
Transferring Using a DV Cable
You can transfer recordings to a computer equipped with a IEEE1394 (DV) terminal or
IEEE1394 capture board. Use the editing software supplied with your computer/capture
board to transfer video recording from tape to computer. Refer to the instruction manual of
the software. A driver is preinstalled on Windows operating systems later than Windows
98 Second Edition and Mac operating systems later than Mac OS 9, and will be installed
automatically.
Operation may not work correctly depending on the software and the
specifications/settings of your computer.
If the computer freezes while you have connected the camcorder, disconnect
and reconnect the DV cable. If the problem persists, disconnect the interface
cable, turn off camcorder and computer, turn camcorder and computer back on
and reconnect them.
Make sure that camcorder and computer are not connected with a USB cable
before connecting the camcorder to the computer using the DV cable.
Otherwise, the computer may not operate properly.
We recommend powering the camcorder from a household power source while
it is connected to the computer.
Refer also to the instruction manual of the computer.
Users of Windows XP can download the DV Messenger software from below
homepage. With DV Messenger, you can perform a videoconference using your
camcorder. For details, refer to the DV Network Software Instruction Manual
supplied with the software.
www.canondv.com
www.canon.ca
www.canon-asia.com
86
IEEE1394 (DV) terminal
Commercially available DV cable
6-pin
4-pin